BEND-ALL 006 is an extreme duty synthetic lubricant formulated to lubricate draw bending operations on tube and pipe. It forms a high strength boundary film and provides extreme pressure lubrication between the mandrel and tube. BEND-ALL 006 will not slump or run off the mandrel even under high temperatures. BEND-ALL 006 was developed for bending and end-forming operations on steel, stainless steel, aluminized, titanium, inconel, and aluminum tubing.
BEND-ALL 006 should be used as a concentrate for difficult bending operations. For lighter duty bending, it may be diluted up to 1:1 with water. It can be applied through automatic mandrel rod lubrication systems capable of pumping higher viscosity fluids or greases. BEND-ALL 006 can be cleaned in an immersion cleaner or in a pressure wash system using TOWERKLENE Saf-T-24. Both immersion and spray wash systems can be run at ambient temperature. The cleaning cycle time can be reduced by increasing the bath temperature to 130 - 160° F. Store BEND-ALL 006 above 40° F. and keep the container closed when not in use. Best if used within six months.
The product is not specified as hazardous waste or pollutant of the environment/water. It is biodegradable. Follow local governmental rules and regulations for waste treatment. The product is not miscible with acids, alkalis or solvents. Devices can be painted with epoxy paint or other coatings injurious surfaces.
Product should be stored under cover in clean, dry conditions and protected from frost. Indoors. Recommended storage temperature ideally between 5°C (41°F) and 35°C (95°F). A shelf life of 6 months can be anticipated.